Saw Trax FS52SM Sign Maker Full Size 52 in. Cross Cut Vertical Panel SawSaw Trax Model: stxnfs52sm
Product Features & specs :
Saw Trax FS52SM Sign Maker Full Size 52 in. Cross Cut Vertical Panel Saw
Today's sign shops have needs that are unique to their industry. Restricted floor space, exceptional dust sensitivity and a wide variety of substrates and composite materials of different thicknesses are just a few. They use cutting-edge materials to stand up to the different environments where their work will be displayed. In the past, you needed two cutters, a panel saw for your rigid material and a substrate cutter for your softer material. This arrangement was expensive and took up twice the floor space.
Has a 7.25 in. blade that can be easily changed and replaced when needed
Sealed Steel Bearing system for smooth and precise pulls on the guide tubes
Patented Accu-Square system to keep your cuts precise
Interchangable insert plates with additional accessories and cutting options
Stop Block with Bar, and Measuring Tapes is able to be used on either side of the unit
Full Size 52 in. Sign Makers Vertical Panel Saw - FS52SM
Makita 5007F Saw
Spinning Saw Insert Plate
Dust hood, hose, and Dust Containment Brush
Folding Stand and Transport Wheels
Dual Rip Gauge
Stop Block with Bar, and Measuring Tapes
Spring Hold-Down Bar
Pivoting Knife Cutter
OLFA(R) Pivoting Knife Insert Plate
Cross Cut Capacity
Q & A :
Every Saw Trax Vertical Panel Saw is thoroughly inspected before leaving the factory. It is warranted to be free from defects from workmanship and materials for one year on all components except the saw motor. Should any trouble develop during the warranty period, contact us for a RMA & return that component with proof of purchase date, freight prepaid to Saw Trax Mfg. Co. Inc. If inspection shows the trouble caused by defective workmanship or materials, Saw Trax Mfg. Co. Inc. will repair (or, at our option, replace) without charge.
This warranty does not apply where:
- - Repairs have been made or attempted by others.
- - Repairs are required because of normal wear and tear.
- - The tool has been abused, misused or improperly maintained.
- - Alterations have been made to the tool.
- - Corrosion and / or rust have developed due to scratches in the finish.
- - The saw motor is covered by the saw manufacturerâ€™s warranty and is not covered by Saw Trax Mfg., Inc.
In no event shall Saw Trax Mfg. Co., Inc. be liable for any indirect, incidental or consequential damages from the sale or use of this product. This disclaimer applies both during and after the duration of this warranty.
Saw Trax Mfg. Co. Inc. disclaims liability for any implied warranties, including (but not limited to) implied warranties of â€œmerchantabilityâ€ and/or â€œfitnessâ€ for a specific purpose, after the term of this warranty.