NOCO GCP1 13 Amp 125V AC Port Plug with Extension Cord

Model: nocngcp1
        (2) Write A Review

We’re sorry, but this item is no longer available.

CA Residents
Prop 65 Warning
compliance warning icon
WARNING: Cancer and Reproductive Harm -- www.P65Warnings.ca.gov
NOCO GCP1 13 Amp 125V AC Port Plug with Extension Cord Model: nocngcp1

Product Features & specs :

NOCO GCP1 13 Amp 125V AC Port Plug with Extension Cord

Details
The GCP1 is an AC Port Plug with an integrated extension cord (16 inches) that offers optimal flexibility and ease of installation. It can mount to the exterior of any vehicle to make the charging port accessible in a more convenient location. Quickly plug-n-play with any extension cord and requires zero cord modifications or hand wiring. Its sleek, ultra low-profile design works seamlessly on any application and includes a snap-fit cap for a watertight seal. Perfect for engine block heaters, battery chargers, home improvement and much more, this unit provides endless possibilities. It is rated for use at 13 Amps, 125 volts, UL certified and fits into any standard 2 inch hole size.
Features:
  • Peak performance rated at 13 Amps and 125V
  • Integrated extension cable (16 inches) requires no cable modification
  • Easy installation (2 inch hole size) with a watertight seal and snap-fit cap
  • Full-sized AC prongs for maximum conductivity
  • Ultimate flexibility makes it perfect for engine block heaters, battery chargers, home improvement and more
What’s Included:
  • 13 Amp 125V AC Port Plug w/ Extension Cord - GCP1
Length
16 in.
Weight
0.47 lbs.
CSA Safety
No
ETL Safety
No
Quantity
5
Type
AC Port Plug with Extension Cord
UL Safety
Yes

Reviews :

4.5 / 5.0
2 Reviews
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
1
1
0
0
0
Would you recommend this product?
Yes (1)
Pros
Easy To Use (1)
Best Uses
Frequent Use (1)
Jobsite (1)
Would you recommend this product?
Yes
Pros
Easy To Use
Best Uses
Frequent Use
Jobsite
Did the job
I installed the device in the sidewall of my trailer. I cut a 2 inch hole in both sides the trailer wall like they said in the directions the only problem I had was on the inside. The device was now far enough in to clear the plywood on the inside the cord would hit the bottom of the plywood, so I had to carve out the plywood a little bit, screws were supplied but they weren't long enough and I siliconed it in. I wish they would make one with a higher amperage it was very hard to find a heater less than 13 amps
November 1, 2018
Purchased
1 year ago
Describe Yourself:
Professional
Just what I wanted,work out great,extremely easy to install everyone should get one.
March 5, 2017

Q & A :

Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!