H & S Autoshot 1080 Uni-Clamp Multiple Welding Stud Puller

Model: unin1080
ratings        (0) Write The First Review

This item is temporarily out of stock. Want an email when it’s back in stock?

H & S Autoshot 1080 Uni-Clamp Multiple Welding Stud Puller Model: unin1080

Product Features & specs :

H & S Autoshot 1080 Uni-Clamp Multiple Welding Stud Puller

The Uni-Spotter people, H&S Autoshot are manufacturers of world class tools and equipment for the automotive industry.
The 1080 Uni-Clamp has been designed to progressively pull heavy hits on structural repairs as well as lighter repairs such as creases on body panels.
A series of up to 11 studs are welded closely together on a panel using the 1045 Eliminator Side by Side Adapter. Each stud takes up to 500 lbs. of pull.
The Uni-Clamp is then tightened onto all of the studs and the pull is made. As the dent is removed, one section will always come out first. The screws securing the studs on that repaired area are loosened eliminating any more pulling on that area. By tightening and loosening the screws, the pull can be controlled to only pull on the low spots of the dent. The end result is a flat, even repair.
  • Uni-Clamp allows you to pull 2 to 11 studs with body frame equipment or even a come-along
  • Uni-Spotter HS 1002 heavy-duty studs are recommended
  • Spacing of studs is not important as studs are flexible and easily bent to fit close hole pattern
  • Use included screw wrench to tighten each stud into Uni-Clamp
  • Use narrow 5 hole side for tighter areas, use wide 11 hole side for larger pulls
What’s Included:
  • Uni-Clamp Multiple Welding Stud Puller - 1080
2 studs - 11 studs
Case Included
Number of Tools
Warranty Term
1 Year

Reviews :

There are no reviews for this item. Write Review

Q & A :

Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!