GearWrench 80578 10 pc. 3/8 in. and 1/2 in. Dr. Metric Hex Bit Socket SetGearWrench Model: kdtn80578
Product Features & specs :
GearWrench 80578 10 pc. 3/8 in. and 1/2 in. Dr. Metric Hex Bit Socket Set
Patented bit holding system forces bit surface to opposing side for maximum bit retention, Entry angle guides fastener, Serration depth as deep as the fastener, Large hard stamped identification, KD Sockets use a Double Line (SAE) and Knurled Line (mm) to easily identify Standard vs. Metric Sockets, Packaged in patented impact resistant "slide rail" system for easier positioning of sockets. Internal slides eliminate interference. Features Ball Bearing Retention Set Includes: 4, 5, 6, 7, 8, 9, 10, 12, 14,
17mm Bit Sockets
Entry angle guides fastener
Serration depth as deep as the fastener
Large hard stamped identification
10 pc. 3/8 in. and 1/2 in. Dr. Metric Hex Bit Socket Set - 80578
No. of Pieces
Hex Bit Metric Socket Set
3/8 in / 1/2 in
Q & A :
Apex Tool Group, LLC
1000 Lufkin Road
Apex, NC 27539
GearWrench® hand tools are warranted for Life to be free of defects in material and workmanship. Carrying cases, pouches, accessory bits and consumable products, if any, are not covered by this Warranty.
GearWrench - Consumer Tools
If any GearWrench Hand Tool purchased at a retailer, when used for its intended purpose, fails to give you complete satisfaction, please return it to the retailer location where purchased, or contact Apex Tool Group Consumer Division at (888)-757-1812 for free replacement or return.
GearWrench - Professional Tools
If use of any GearWrench Hand Tool® when used for its intended purpose, fails to give complete satisfaction, return it to your GearWrench Distributor or contact Apex Tool Group Professional Division at (800)-688-8949, and it will be repaired or replaced free of charge.
*Except Torque Products
*GearWrench Torque Products are warranted to (1) be free of defects in material and workmanship for one year and (2) meet out of the box calibration accuracy standards as stated in the product literature. Accuracy standards for calibration are warranted for 90 days from date of purchase. Products for which Warranty Repair is requested should be returned, at Buyer’s cost, for evaluation to:
Warranty Service & Authorized Repair:
Electronic Torque Wrenches
Apex Torque Repair
3000 West Kingsley Road
Garland, TX 75041
All other Torque Products:
Angle Repair & Calibration Service, Inc.
175 Angle Drive
Beckley, West Virginia 25801
GearWrench Torque Products are precision instruments that contain moving parts. These components are subject to normal wear through use and replacement thereof is the responsibility of Buyer. Torque Products should be routinely checked for calibration at an Authorized Repair Center using GearWrench repair parts.